Filter
Top Products
28 en | Installing the DINION capture DINION capture 5000 IP
| 1.0 | 2012.01 Installation Manual Bosch Security Systems, Inc.
3. Connect the other end of the coax cable to a monitor.
4. Ensure that power is restored to the imager.
5. Press and hold the center key (item 2) for approximately
two seconds. The BNC video output is activated and the
Install menu appears on the monitor.
6. Adjust settings and setup camera positioning as required.
7. Press and hold the center key a second time to return the
video signal back to the Ethernet connection. Release the
button once the BNC connection loses the video signal.
8. Replace the back panel using the four hex socket screws
and the supplied 3 mm hex key.
3.7 Using a microSD Card
The DINION capture 5000 IP supports most microSD cards
(SDHC). For a list of recommended cards (not supplied by
Bosch), please visit www.boschsecurity.com.
To insert a microSD card: