Filter
Top Products
DINION capture 5000 IP Installing the DINION capture | en 23
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2012.01
6. Adjust the tilt angle of the camera by loosening the tilt bolt
(item 1, below) with the 5 mm hex key and the set screw
(item 2) with a flat head screwdriver.
7. Place the license plate camera at the desired tilt angle and
tighten the tilt bolt and the set screw.
8. Adjust the pan angle of the camera by loosening the pan
bolt, located beneath the bracket mounting head, by
loosening the pan bolt using the 5 mm hex key. Place the
license plate camera at the desired pan angle and tighten
the bolt.