Filter
Top Products
MIC Series 550 Camera Getting Started | en 25
Bosch Security Systems, Inc. User Manual F.01U.239.454 | 3.0 | 2012.09
To navigate the OSD menus:
1. Use the joystick to highlight a menu item.
2. Press either the Focus or the Iris key to open a menu item.
3. Follow the on-screen instructions.
Note: To select the Exit Menu item from anywhere in the current menu, use the Zoom
command.
6.3.2 Basic Keyboard Operation
The following tables summarize the basic operations for a standard keyboard and the
functions available to control a MIC-550 camera.
Table 6.1 Typical Keyboard Functions
Table 6.2 Typical Keyboard Controls for a MIC-550 Camera
6.3.3 Keyboard Commands, Bosch Protocol
Keyboard control commands are composed of a sequence of three (3) inputs with the
following convention: 1) a Function key + 2) a Command number key(s) + 3) the Enter key.
– Depending on the type of keyboard, the control function keys are labeled:
ON or AUX ON
OFF or AUX OFF
SET or SET SHOT
SHOT or SHOW SHOT
– Command numbers range from 1 to 999. See Section A Keyboard Commands by Number,
page 59 for a complete list of keyboard commands.
– The Enter key can also be labeled with the ∞ symbol.
For example, the keyboard command to make the MIC-550 pan 360º continuously is:
ON-1-ENTER (Press the ON key, then press the number 1 key, and then press ENTER.)
Typical Keyboard
Features
Usage
Function Keys Selects a specific control setting.
Number Keys Inputs a number from 0 to 9.
Camera Key Selects a camera number.
Enter Key Inputs a selection.
Focus Key Sets the lens focus or makes a menu selection in OSD mode.
Iris Key Sets the lens iris setting or makes a menu selection in OSD mode.
Key LEDs Indicates an active key.
LCD Displays the current status.
Joystick Controls the pan/tilt/zoom (PTZ) functions of the camera.
Camera Operation How to control
To Pan Side to Side Move the joystick left or right.
To Tilt Up and Down Move the joystick forward and back.
To Zoom In Twist the joystick clockwise.
To Zoom Out Twist the joystick counterclockwise.
NOTICE!
The convention used for control key commands in this manual is ON, OFF, SET, and SHOT.
Refer to your keyboard manual for the key naming conventions.