Filter
Top Products
MIC Series 550 Camera Common User Commands (unlocked) | en 53
Bosch Security Systems, Inc. User Manual F.01U.239.454 | 3.0 | 2012.09
9.8 Remapping Aux Commands (Pelco Protocol, firmware version
2.10 and higher)
The Pelco protocols (D and P) support 8 different auxiliaries, but do not define what
functioneach should perform. This feature enables the 8 available auxiliaries to be set to any
of the 8 available functions (WASH WIPE, IR Illuminator, Backlight Comp, Alarm Output 1,
Alarm Output 2, Alarm Output 3, Alarm Output- 4, Not Set).By default, the Aux numbers of the
functions are mapped as follows in MIC550:
To change a mapping, select the auxiliary number from the 8 available, press right to select,
and then scroll through the available functions using up and down control inputs.
For example, to remap the Aux command for the wiper in the MIC550 camera to match the
number of the Aux command used in an existing installation, follow these steps:
1. Select option one ("WASH WIPE" by default). Set the value to "Not Set."
2. Select option two ("Alarm Output 2" by default). Set the value to "WASH WIPE." The
MIC550 camera will now activate the wash/wipe function in response to the Aux 2
command.
9.9 Using the Washer/Wiper (Pelco Protocol)
To activate the washer/wiper in Pelco protocol, follow these steps:
1. From the submenu Wiper Mode in the menu Camera Setup, select "WASH WIPE," and
then exit the menu.
2. Position the camera so that the nozzle of the washer will spray the camera window.
3. Press 62 and then Preset. Press and hold "Preset" for 2 seconds until the text "Scene 62
Stored" appears on the OSD. (See *** 'Setting Preset Shots' on page 50 ***).
Note: If you already have a preset stored at that position, the system prompts you to
overwrite the current scene.
4. Activate the wash/wiper function. Press 1 and then AUX-ON on the keyboard. The camera
moves to preset 62. The nozzle sprays cleaner onto the camera window, and then the
wiper wipes the window. The camera then returns to where it was positioned previously,
or it continues to perform the tour that it was performing when you activated the wash/
wipe function.
1WASH WIPE
2 Alarm Output 2
3 Alarm Output 3
4 Alarm Output 4
5Not Set
6Not Set
7Not Set
8Not Set
NOTICE!
Depending on your camera settings, your monitor may display a freeze frame image of the
wiper during or at the end of the wipe cycle. If you prefer not to see this freeze frame, you can
turn off the Freeze Frame on Preposition in the PTZ Setup menu.