Filter
Top Products
MIC Series 550 Camera On-Screen Display (OSD) Menus (Bosch Protocol) | en 41
Bosch Security Systems, Inc. User Manual F.01U.239.454 | 3.0 | 2012.09
Selecting a Rule number provides access to its configuration menu. The Rule # Menu allows
you to configure a rule from previously-defined alarm inputs and outputs. Once an alarm is
configured with valid inputs and outputs, it can be turned on or off (enabled or disabled)
through its configuration menu.
Rule # Choices:
Rule Setup Displays the status of rules and lets
you add new rules or modify an
existing rule.
Rule 1-12 Displays the status of a rule on the
right side of the menu. There are four
(4) possible rule statuses.
Enabled: The rule inputs and
outputs are properly defined
and the rule is turned on.
Disabled: The rule inputs and
outputs are defined but the rule
is turned off.
Invalid: The rule has a missing
or invalid input or output.
Empty: The rule has no inputs
or outputs defined.
Empty
Menu Description Submenu / Description Default
Setting
Menu Description Submenu / Description Default
Setting
Exit Saves and exits the menu.
Enabled Turns the rule on or off after its inputs
and outputs have been defined.
YES to enable or NO to disable NO
Input Toggles through a list of valid inputs set
in the Alarm I/O Setup > Inputs Setup
Menu that define the rule's inputs. A
rule can have up to four (4) inputs.
Inputs which were set in the Inputs
Setup Menu, including Aux On/Off (1-
99), Shot, and NONE.
NONE
Output Toggles through a list of valid outputs
set in the Alarm I/O Setup > Outputs
Setup Menu that defines a rule's
outputs.
Outputs set in the Outputs Setup
Menu including: Alarm Relay, Aux On/
Off (1-99), Shot, OSD, Transmit, and
NONE.
Some outputs, such as Alarm Outputs
1-3, Alarm Relay, and Aux On/Off can
be set to be active for a specific
duration of time as follows:
Seconds: 1-5, 10, 15, or 30
Minutes: 1-5 or 10
Latched: The alarm stays active until
acknowledged.
Follows: The alarm follows the alarm
rule.
NONE
NOTICE!
You can include up to four (4) Input and Output events in a single rule. Each input and output,
however, must be true for the alarm's rule to be valid and enabled.