Filter
Top Products
50 en | Common User Commands (unlocked) MIC Series 550 Camera
F.01U.239.454 | 3.0 | 2012.09 User Manual Bosch Security Systems, Inc.
9 Common User Commands (unlocked)
This chapter details common user commands. See Section A Keyboard Commands by Number,
page 59, for a complete list of commands.
9.1 Setting AutoPan Mode
AutoPan mode pans the MIC-550 camera 360º or pans between user-defined limits (when
programmed). The MIC-550 camera continues to pan until stopped by moving the joystick.
To pan 360º:
1. Press ON-1-ENTER.
2. Move the joystick to stop the pan.
To set left and right pan limits:
1. Move the camera to the starting position and press SET-101-ENTER to set the left limit.
2. Move the camera to the end position and press SET-102-ENTER to set the right limit.
To start AutoPan between limits:
1. Press ON-2-ENTER.
2. Move the joystick to stop the pan.
9.2 Setting Preset Shots
Preset shots are saved camera positions. Shots are saved as scenes, therefore, the terms
SHOT and SCENE are used interchangeably.
To set a Shot:
1. Move the camera to the position you want to save.
2. Press SET-#-ENTER, where # can be a number from 1 to 99 that identifies the camera
position of the scene.
3. To specify a title for the shot, see the procedure below.
To view a Shot:
Press SHOT-#-ENTER, where # is the number of the scene position that you want to view.
To store or clear a Shot:
1. Press SET-100-ENTER to access the Store/Clear Scene Menu.
2. Follow the on-screen instructions.
To disable overwrite confirmations:
If you overwrite a preset shot, the MIC-550 issues a confirmation message prompting you to
approve the overwrite. To disable this confirmation message, press OFF-89-ENTER.
9.3 Specifying a Shot or a Sector Title
The MIC-550 provides an alphanumeric character palette used to specify a title for a shot
(scene) or for a sector (zone).
To specify a title:
1. Navigate to the shot or scene:
– for a shot: set a new shot or view a stored shot, then press ON-62-ENTER.
– for a scene: move the MIC-550 to the scene (zone), then press ON-63-ENTER.
2. Use the joystick to move the cursor to highlight a character.
3. Press Focus/Iris to select the character.
4. Continue to select characters (up to 20) until you have created the title.