Filter
Top Products
52 en | Common User Commands (unlocked) MIC Series 550 Camera
F.01U.239.454 | 3.0 | 2012.09 User Manual Bosch Security Systems, Inc.
9.6 Recording Tours
The MIC-550 can make up to two (2) recorded tours. A Recorded Tour saves all manual
camera movements made during the recording, including its rate of pan, tilt and zoom speeds
and other lens setting changes.
To Record Tour A:
1. Press ON-100-ENTER to start recording a tour.
2. Press OFF-100-ENTER to stop recording.
To playback Recorded Tour A:
1. Press ON-50-ENTER to begin continuous playback.
2. Press OFF-50-ENTER or move the joystick to stop playback.
To Record Tour B:
1. Press ON-101-ENTER to start recording the tour.
2. Press OFF-101-ENTER to stop the tour.
To playback Recorded Tour B:
1. Press ON-52-ENTER to begin continuous playback.
2. Press OFF-52-ENTER or move the joystick to stop playback.
9.7 Using the Wiper/Washer (Bosch Protocol)
To activate the washer/wiper function, press ON-105-ENTER and confirm this sequence:
1. The wiper moves to a predefined position.
2. The washer turns on for five seconds. SImultaneously, the wiper turns on and wipes five
times.
3. The washer turns off. The wiper turns off.
4. The camera returns to its previous PTZ position (and to inactive mode if applicable).
To activate the wiper manually (or if the corresponding alarm was activated or
deactivated):
Press ON-102-ENTER.
Note: The wiper will turn off automatically after 5 minutes of use.
To activate intermittent wipe:
Press ON-103-ENTER. The wiper wipes twice, then turns off 15 seconds later, after it
returns to parked position.
To activate the wiper to wipe five (5) times:
Press ON-104-ENTER. The wiper wipes five times, then turns off after it returns to parked
position.
NOTICE!
If the power fails while the wiper is activated, the wiper will return to ’parked’ position, after
power is restored, before turning off. The wiper will not stop in front of the camera window.