Filter
Top Products
AutoDome 800 Series HD PTZ Camera Installing Roof Parapet and Pipe Mounts | en 39
Bosch Security Systems, Inc. Installation Manual F.01U.273.797 | 5.0 | 2012.08
3.4.1 Wiring the Power Supply Box
1. Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box.
2. Cut and trim the high voltage 115/230 VAC power and ground wires with sufficient slack
to reach their connector terminal in the box, but not so long as to be pinched by or to
obstruct closing the Cover Door. See Section 3.1.1 Parts List, page 33, for connector
location.
3. Attach the supplied 3-pin Power Plug to the incoming high voltage power wires in the
box. See connector P101 in Table 3.1, Page 42.
4. Route the low power 24 VAC wires from the right side of the Power Supply Box out to
where the AutoDome will be mounted. Attach the supplied 5-pin 24 VAC Dome plug to
the wire ends inside the box. See connector P107 in Table 3.1, Page 42.
5. Route the Ethernet cable out to where the AutoDome will be mounted. See
Section 4 Cable and Wire Standards, page 51 for fiber optic specifications.
3.4.2 Wiring the Fiber Optic Model
If installing a Fiber Optic model, bring the fiber optic cable into the right side of the
power supply box.
NOTICE! The Power Supply Box with transformer comes with a barrier that separates the high
voltage side on the left from the low voltage 24 VAC side on the right.
NOTICE! All ethernet and alarm wires either pass through the Power Supply Box or by-pass it
and connect directly to the Pipe Interface Board.