Filter
Top Products
86 en | Configuring the AutoDome 800 Series AutoDome 800 Series HD PTZ Camera
F.01U.273.797 | 5.0 | 2012.08 Installation Manual Bosch Security Systems, Inc.
High Sensitivity Setting
Night Mode
Selects night mode (B/W) to enhance lighting in low light scenes. Select from the following
options:
– Off: Forces the camera to stay in Nigh Mode and transmit monochrome images.
– On: The camera does not switch to Night Mode regardless of ambient light conditions.
– Auto: The camera switches out of Night Mode after the ambient light level reaches a pre-
defined threshold.
Night Mode Threshold
Adjusts the level of light at which the camera automatically switches out of night mode (B/W)
operation. Select a value between 10 and 55 (in increments of 5), where 10 is earlier and 55 is
later.
Noise Reduction
Turns on the 2D and 3D noise reduction feature.
Noise Reduction Level
Adjusts the noise level to the appropriate level for shooting conditions. Select a value
between 1 and 5.
7.23 Lens Settings
Auto Focus
Continuously adjusts the lens automatically to the correct focus for the sharpest picture.
– One Push (default): activates the Auto Focus feature after the camera stops moving.
Once focused, Auto Focus is inactive until the camera is moved again.
– Auto Focus: Auto Focus is always active.
– Manual: Auto Focus is inactive.
Focus Polarity
– Normal (default): focus controls operate normally.
– Reverse: focus controls are reversed.
Focus Speed
Controls how fast the Auto focus will readjust when the focus becomes blurred. Select from
the following options:
– Super Slow
– Slow
– Medium
– Fast
Auto Iris
Automatically adjusts the lens to allow the correct illumination of the camera sensor. This type
of lens is recommended for use where there are low light or changing light conditions.
– Constant (default): camera constantly adjusts to varying light conditions (default).
If you select this option, the AutoDome makes the following changes automatically:
– Gain Control: switches to AGC
– Shutter Speed: switches to default
– Manual: camera must be manually adjusted to compensate for varying light conditions.