Filter
Top Products
42 en | Installing Roof Parapet and Pipe Mounts AutoDome 800 Series HD PTZ Camera
F.01U.273.797 | 5.0 | 2012.08 Installation Manual Bosch Security Systems, Inc.
Table 3.1 Power Supply Box Connections
3.5 Installing the VG4-A-9230 Roof Parapet Mount
This section details the installation steps for the Roof Parapet Mount. If you are installing a
pipe mount, see Section 3.6 Installing the VG4-A-9543 Pipe Mount, page 45, for instructions.
Figure 3.5 VGA-A-9230 Parapet Roof Mount
1. Determine the wall location on the roof for the AutoDome and use the Parapet wall
mount bracket as a template to mark the hole locations.
2. Prepare the mounting surface for the type of fastener by drilling holes for the mounting
anchors as required.
No. Connector Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6
Ground Grounding Screw
P101 115/230 VAC or
24 VAC Power In
Line NC Neutral
P105 Data/Audio Audio Audio Earth
Ground
Not Used
P106 Not Used
P107 24 VAC Power
(Arm Harness)
Dome
24 VAC
Dome
24 VAC
Earth
Ground
Heater
(24 VAC)
Heater
(24 VAC)
NOTICE! Allow enough room below the Parapet Mount Bracket to route the video, control and
alarm wires up through the Parapet arm. In certain installations you may have to lift the
Parapet arm for the AutoDome to clear the top of the wall when it is swung into position.
Provide enough slack in the wires to rotate the pipe arm over the roof and back when camera
maintenance is required.