Filter
Top Products
AutoDome 800 Series HD PTZ Camera Configuring the AutoDome 800 Series | en 85
Bosch Security Systems, Inc. Installation Manual F.01U.273.797 | 5.0 | 2012.08
– Sodium Lamp Auto: Automatically adjusts for sodium vapor light to restore objects to
their original color.
– Sodium Lamp: Optimizes the sodium vapor light to restore objects to their original color.
Red Gain
The red gain adjustment offsets the factory white point alignment (reducing red introduces
more cyan).
Blue Gain
The blue gain adjustment offsets the factory white point alignment (reducing blue introduces
more yellow). It is only necessary to change the white point offset for special scene
conditions.
Gain Control
Adjusts the automatic gain control (AGC). Automatically sets the gain to the lowest possible
value needed to maintain a good picture.
– AGC (default): electronically brightens dark scenes, which may cause graininess in low
light scenes.
– Fixed: no enhancement. This setting disables the Max. Gain Level option.
If you select this option, the AutoDome 800 Series makes the following changes
automatically:
– Night Mode: switches to Color
– Auto Iris: switches to Constant
Max. Gain Level
Controls the maximum value the gain can have during AGC operation. To set the maximum
gain level, choose from:
– Normal
– Medium
– High
Sharpness
Adjusts the sharpness of the picture. To set the sharpness, type a value between 1 and 15
inclusive. The default setting is 12.
Shutter Mode
– Off: turns the Auto SensUP Off.
– AutoSensUp: increases camera sensitivity by increasing the integration time on the
camera. This is accomplished by integrating the signal from a number of consecutive
video frames to reduce signal noise.
If you select this option, the AutoDome makes the following change automatically:
– Auto Iris: switches to Constant
Shutter
Adjusts the electronic shutter speed (AES). Controls the time period for which light is
gathered by the collecting device. The default setting is 1/30 second and the range of settings
is from 1/1 to 1/10000.
Backlight Compensation
Optimizes the video level for the selected area of the image. Parts outside this area may be
underexposed or overexposed. Select On to optimize the video level for the central area of
the image. The default setting is Off.