Filter
Top Products
23
Preparations
E
Step 3: Using the Wireless Controller
Inserting the Battery (Lithium Button Battery CR2025)
1. Press the tab in the direction of
the arrow and pull out the battery
holder.
2. Place the lithium button battery
with the + side facing up.
3. Insert the battery holder.
Using the Wireless Controller
Point the controller at the
camcorder’s remote sensor when
you press the buttons.
The wireless controller may not work properly when the remote sensor is
situated under strong light sources or direct sunlight.
If the wireless controller does not work, check that the remote sensor is not set
to [OFF ] ( 81).
When the camcorder cannot be operated with the wireless controller, or when it
can only be operated at a very close range, replace the battery.
Tab
DC 20_10_PAL-E.book Page 23 Friday, September 2, 2005 6:36 PM