Filter
Top Products
54
Using the Flash
You can use the built-in flash for recording still images in dark places. The flash is
equipped with the red-eye reduction function.
1. Set the camcorder to record still images ( ) and select a
recording program other than Fireworks (SCN).
2. Press the (flash) button.
• Repeatedly pressing the button will cycle between the flash modes.
• The symbol of the selected flash mode appears on the screen. “ ” disappears after
4 seconds.
3. Press the PHOTO button, first halfway to activate the autofocus and
then fully to record the still image.
The flash fires according to the flash mode selected and the recording conditions.
Do not fire the flash close to people’s eyes.
Do not fire the flash at people while they are driving.
Do not fire the flash with the flash bulb covered with your hand.
The practical range of the flash is approx. 1 to 2 m. The range depends upon
the recording conditions.
The range of the flash decreases in continuous shooting mode.
For the red-eye reduction to be effective, the subject needs to look at the assist
lamp. The degree of reduction depends on the distance and on each individual.
The flash will not fire in the following cases:
- When you press the EXP button in (auto) or (red-eye reduction) mode.
- During auto exposure bracketing.
(auto) The flash fires automatically according to the brightness
of the subject.
(red-eye reduction, auto) The flash fires automatically according to the brightness
of the subject. The assist lamp lights up to reduce the
red-eye effect.
(flash on) The flash always fires.
(flash off) The flash does not fire. Use this setting in places where
flash photography is prohibited.
PHOTO button
Flash
(flash) button
Assist lamp
DC 20_10_PAL-E.book Page 54 Friday, September 2, 2005 6:36 PM