Filter
Top Products
A-11
4. Use [8], [2], [4], and [6] to select “Swing Burst” and then press
[SET].
The following are the initial default Prerecord CS settings used for Swing Burst.
• You can use the Control Panel to change the above settings, if you want.
• When you select “Swing Burst” with the BEST SHOT scene menu the High
Speed CS, Maximum CS Shots, and Prerecord CS Shots settings (which you
can configure using the Control Panel) are automatically set to the initial default
settings shown above.
5. Half-press the shutter button.
This will start updating of the pre-record buffer with images. Buffer contents are
continually updated until you full-press the shutter button.
• If you release the half-pressed shutter button before pressing it the rest of the
way down, all of the images currently in the pre-record buffer will be deleted.
• The camera will not emit shutter sounds as it pre-records images.
6. Press the shutter button the rest of the way and hold it down.
This will save the pre-recorded images and start shooting new images in real-
time. Images continue to be shot as long as you keep the shutter button
depressed or until the maximum number of images is reached.
NOTE
• Pre-recording of images is not performed if you full-press the shutter button without
half-pressing first. Whenever possible, be sure to half-press the shutter button and
wait for a while before full-pressing.
High Speed CS Maximum CS Shots Prerecord CS Shots
10 fps 30 images 5 images