Filter
Top Products
iDP3210 User’s Manual
18
CITIZEN
Print Head overheat : To protect print head from excessive heat, in case the temperature of print head goes
high(approx. 65°C or over), head temperature sensor works and has ERROR LED
illuminate, then stops printing operation. After head temperature is cooled (Approx.
60°C or less), printing operation automatically starts.
Paper near end : When the remaining of roll paper goes scarce, paper near end sensor located on the
side of roller portion of the upper cover works, and has ERROR LED illuminate to
show the remaining of roll paper is getting scarce. (See “setting of paper end detector
effective for outputting a signal for no paper” and “setting of paper end sensor
effective for print stop” in the chapter of print control function.)
Paper end : When the roll paper runs out completely, the paper sensor located in the paper course
near to print head detects the end of print paper and has ERROR LED illuminate, then
stops printing operation. (See “setting of paper end sensor effective for outputting a
signal for no paper” and “setting of paper end sensor effective for print stop” in the
chapter of print control function.) When the paper is inserted into the paper course
near to print head, roll paper is automatically loaded.
Cutter motor lock : In case that cutter position sensor locates in the auto cutter unit keeps ON or OFF for
one second or more during the operation of cutter motor, this sensor detects it as motor
lock state. And then, this stops cutter operation and printing operation. (See the
chapter of 4.5 “cancellation of cuter lock”)
(3) FEED Switch
With this pressed once shortly, paper is fed by one line. With this kept pressed, lines are fed continuously.
In case of macro execution wait, this is executed by pressing FEED switch.
(4) FEED Switch and Power Switch
By turning ON power switch with pressing FEED SWITCH, , self printing is performed.