Filter
Top Products
iDP3210 User’s Manual
38
CITIZEN
(9) Specifying/ Canceling Underline (ESC - n)
Code: [1B]h + [2D]h + n
*{0≤ n ≤ 02} Data is described in Hex code.
Specifying/canceling an underline.
• An underline is attached to the full character width. It is, however, not attached to the par t having been
horizontal tab command.
• An underline is not attached to a 90°- right-turned characters.
• Types of underlines by n value are shown below:
n (Hex) Type
0 Canceling an underline.
1 Specifying an underline for 1-dot width.
2 Specifying an underline for 2-dot width.
(10) Specifying 1/6 inch line feed rate (ESC 2)
Code : [1B]h + [32]h
The line feed rate per line is specified by 1/6 inch.
(11) Setting line feed rate n/203 inch (ESC 3 n)
Code : [1B]h + [33]h + n
*{0≤ n ≤ FF} Data is described in Hex code.
The line feed rate per line is specified by n/156 inch.
•The initial value is n = 26(18H), being 4.23 mm line feed rate.
(12) Initializing Printer (ESC @)
Code : [1B]h + [40]h
Clears data stored in the print buffer and brings various settings to the initial state (Default state).
•Data inside the internal input buffer are not cleared.
•Dip switches are read once again.