Filter
Top Products
iDP3210 User’s Manual
53
CITIZEN
(38) Data Input Control (ESC = n)
Code : [1B]h + [3D]h + n
*{0≤ n ≤ FF} Data is described in Hex code.
Selecting equipment in which data input from the host is effective.
•Each bit of n indicates as follows:
Va lu e
Bit Equipment 0 1
0 Printer Invalid Valid
1 Not defined
2 Not defined
3 Not defined
4 Not defined
5 Not defined
6 Not defined
7 Not defined
• When the printer has not been selected, this printer abandons all received data until it is selected by this
command.
• Even when the printer has not been selected, it can become BUSY state through printer operation.
• The initial value of n is "1".