Filter
Top Products
iDP3210 User’s Manual
54
CITIZEN
(39) Aligning the characters (ESC a n)
Code : [1b]h + [61]h + n
*{0≤ n ≤ 2} Data is described in Hex code.
All the printed data within one line are aligned in the specified position.
•Depending on n value, positional alignment is carried out as in the table below:
n (Hex) Position
0 Left end alignment
1Centering
2 Right end alignment
• This is valid only when n is inputted at the beginning of line.
• The initial value of n is "0".
(40) Full Cut (ESC i)
Code : [1B]h + [69]h
Full cutting of paper is performed.
•This is valid only when n is inputted at the beginning of line.
•This is valid only when DS1 -1 is ON.(Paper cutter enabled)
(41) Partial Cut (ESC m)
Code : [1B]h + [6D]h
Partial cutting of paper is carried out.
•This is valid only when n is inputted at the beginning of line.
•This is valid only when DS1-1 is ON.(Paper cutter enabled)