32D-Link DCS-1100/1130 User Manual
Section 4 - Conguration
Recording Options
Resolution: This will let you set which video prole you wish to use to record
video. Please note that if the bitrate (bps) of the video prole is higher than
your Samba network drive’s throughput, the recording’s framerate (FPS) may
be reduced.
Record until: You can use this setting to adjust how much free space must
remain when recording. It is suggested that you set this to at least 32M to allow
for enough buer space for the camera to record with.
When storage is full: When your storage device is full or has reached the free
space limit specied in Record until, you can choose to stop recording, or you
can have the camera delete old recordings to free space for new recordings to
be saved.
Event Based: Event based recording will allow you to record video when specic
events happen.
Motion detection triggered recording: Enabling this option will set the
camera to record video when motion is detected by the camera.
Prerecord: This will set how many seconds of video before the event takes place
will be recorded.
Postrecord: This will set how many seconds of video after the event takes place
will be recorded.
Example: Using motion detection triggered recording and setting Prerecord to 5 seconds and Postrecord to 9 seconds, the
camera will save video from 5 seconds before motion was detected to 9 seconds after motion was detected.
Continuous: This will set the camera to record continuously.
Scheduled Recording: This will set the camera to automatically record video during the specied times in the table below.
After making any changes, click the Save Settings button to save your changes, or click the Don’t Save Settings button to
discard your changes.
