Filter
Top Products
30 Printing From a Camera or Phone
Printing From a Mobile Phone
If your mobile phone or PDA has a camera and an infrared port, you can send
your photos to the printer and print them directly from your phone or PDA.
1. Make sure the printer is not printing.
2. Load the type of paper you want to use (see page 7).
3. Press
Setup to enter the Setup menu.
4. Press l or r to select
PictBridge Settings, then
press
OK.
5. Press l or r to select your print settings,
as described on page 21.
6. After you select the settings you want, press
OK.
Note:
These settings remain in effect until you change them, so you only need to set
them the first time you print from your phone or PDA. To reset all settings to their
defaults, see page 27.
7. Hold your phone less than 8 inches away from the infrared port on the
printer. Aim your phone’s or PDA’s infrared port at the printer’s port, and
send your photos. See your mobile phone manual for details.
Note:
You can send up to 10 photos (the maximum total image size is 3 MB), including photos
that are being printed.
You may not be able to transmit if direct sunlight or fluorescent light is shining onto
either of the infrared ports.
The printer is compliant with infrared IrDA Standard Specifications, Ver.1.3 Low Power.
The maximum data rate is 4 M bits/second.
Less than 8 inches