Filter
Top Products
95
• Specified string is too long.
Cause: The specified string is too long. Up to 128 en-size characters and up
to 64 em-size characters can be specified.
User response: User response: Reduce the number of characters in the string so that
they do not exceed 128 en-size characters. Then, try scanning again.
• Cannot specify next words for filename. \:;?”<> .
Cause: The specified filename contains one or more of the following
characters: \:;?”<>
.
User response: Enter a file name that does not contain the above characters. Then,
make the settings again.
• The image scanner not found.
Cause: Possible causes include the following: an image scanner that is not
supported by this driver has been connected, no image scanner has
been connected, or the cable is not connected.
The scanner is used by other application.
(This Driver can’t be used at the same time with more than one
application.)
User response: Check the connection of the image scanner.
Check that the scanner is not used by other application.
(In the case of Windows
®
XP, [Switch User] lets another user log on
while your programs and files remain open. Therefore, when you log
on with [Switch User], it has the possibility that another user have
already used the driver.
• The specified image scanner is being used.
Cause: The image scanner may be already in use by another application, or
the TWAIN driver may have been started twice.
User response: After all applications are terminated, restart the image scanner for
scanning.
• Selected scanner is used by other application or not connected.
Cause: 1. The scanner may be OFF or not connected.
2. The scanner may be already in use by other application or the
“Scanner and Camera” in [Control Panel].
User response: 1. Check the power supply of the scanner or connection with PC.
2. Close other application or “Scanner and Camera” in [Control Panel]
• An input-output error occurred in the image scanner.
Cause: A fault occurred during the scan operation of the image scanner.