Filter
Top Products
43
English
QR34642
REMOVING DISC
1 Set the power switch to
“POWER OFF” to turn the
DVD video camera/
recorder off.
2 Press down the DISC
EJECT button once and
release it.
In a moment, the cover of
disc insertion block will
open slightly.
3 Gently open the cover until
it stops.
When the cover is fully
open, the disc will slightly
come out from the disc
guide, and stop.
4 Remove the
disc.
Hold the top
of Round
DVD
Holder as
shown in the
illustration and gently pull it out.
Note:
Be careful not to touch the disc exposed portion when
removing the disc.
5 Gently push the section
indicated “PUSH CLOSE”
on the cover of disc insertion
block, to close the cover.
Note:
• Itis recommended thatyou turn theDVD videocamera/
recorder off when inserting or removing disc, in order to
prevent faulty operation.
• Evenafterthe DVD videocamera/recorderis turnedon,
the disc can be removed unless it is in recording status.
Hold down the DISC EJECT button for approximately 2
seconds, and then release it to remove the disc. (The
DISC EJECTindicator onthe LCDscreenwill blink.)Itis
recommended that you turn the DVD video camera/
recorder off before inserting orremoving disc toprevent
misoperation.
• Donotdetachthe batteryorAC adapter/chargeruntil the
DVD video camera/recorder is completely turned off.
• Donot insert anything otherthan the8 cmDVD-RAM or
DVD-R disc into the disc insertionblock: Doing socould
cause malfunctions.
• Set the power switch to “POWER OFF” to turn the DVD
video camera/recorder off.
• When inserting or removing the disc, be careful not to
touch the inside of DVD video camera/recorder
(especially, the lens of laser pickup).
• Wheninserting orremoving thedisc, connect acharged
battery orAC adapter/charger tothe DVDvideo camera/
recorder: The disc cover will not open unless the DVD
video camera/recorder is powered.
DISC EJECT
Hold disc
around this
portion.