Filter
Top Products
50
English
QR34642
Recording Movie
Insert a recordable DVD-RAM or DVD-R disc into this DVD video camera/recorder.
1 Turn the DVD camera/recorder on.
Set the power switch to “ VIDEO” to turn the
DVD video camera/recorder on.
After the ACCESS/PC indicator goes out,
perform the subsequent operation:
2 Check the subject on the screen (viewfinder or
LCD).
If using the viewfinder, pull it out.
3 Press the REC button.
The “+” mark in the viewfinder or on the LCD
screen will change to the “,” mark, and
recording will start.
During recording, the recording indicator on the
front of DVD video camera/recorder will light.
Pressing REC again during recording will set the
DVD video camera/recorder to the recording
pause status.
4 When recording is finished, turn the DVD video
camera/recorder off.
Note:
• See page 147 when recording movie is not possible.
• See page 147 if it takes some time before recording is
possible.
• See page 62 for on-screen information display.
• It is recommended that you use DVD-RAM disc from
which recorded contents can be deleted.
• Sound is recorded from the stereo microphone on the
front of DVD video camera/recorder: Take care that this
microphone is not blocked.
• YoucanpresstheRECbuttonimmediatelyaftertheDVD
video camera/recorder enters the recording pause
status,butno furtherrecordingcanbemadewhile“DISC
ACCESS” is being displayed
Recording will restart after the message disappears.
• Take care that power is not interrupted while the
ACCESS/PC indicator is blinking.
• Theminimum recordable timeof movieis approximately
3 seconds.
• See page 93 for setting of Record LED (recording
indicator) On/Off.
• For various functions available during recording, see
“Setting Up Camera Functions” on page 80.
• Hitachi cannot be responsible for video and audio that
cannot be recorded or edited because of any defect.
• The power switch can be changed over even during
recording, but the operation will not be changed.
• Each time the DVD video camera/recorder enters the
recording pause status,the counter display will be reset
to “0:00:00”.
• Whenusing DVD-Rdisc,do notperformthefollowing,or
data on the disc may not be read:
- Using another device, doing additional recording on
DVD-R disc recorded on this DVD video camera/
recorder
- Using this DVD video camera/recorder, doing
additional recording on DVD-R disc recorded on
another device
Power switch
Pressing REC
once will start
recording;
pressing it
onceagainwill
temporarily
stop recording.
ACCESS/PC
indicator