Filter
Top Products
3. Create the Font Resource. Use the CRTFNTRSC command to create an iSeries
font resource.
Creating Overlay Resources
The following section describes how to create overlay resources.
1. Create a temporary resource file as follows. From an iSeries command line,
issue the CRTPF command to create a file to receive the PC resources. The
“Create Physical File (CRTPF)” panel appears.
2. Transfer the overlay file from the folder by using the CPYFRMPCD command:
Create Font Resource (CRTFNTRSC)
Type choices, press Enter.
Font resource . . . . . . . . . FNTRSC newfont
Library . .......... *CURLIB
File..............FILE temppf
Library . .......... qtemp
Member.............MBR *FNTRSC
Text ’description’ . . . . . . . TEXT ’New Character Set’
Bottom
F3=Exit F4=Prompt F5=Refresh F10=Additional parameters F12=Cancel
F13=How to use this display F24=More keys
Figure 114. Create Font Resource (CRTFNTRSC) panel
Create Physical File (CRTPF)
Type choices, press Enter.
File..............FILE > TEMPPF
Library . .......... > QTEMP
Sourcefile ..........SRCFILE QDDSSRC
Library . .......... *LIBL
Source member . . . . . . . . . SRCMBR *FILE
Record length, if no DDS . . . . RCDLEN 32766
Generation severity level . . . GENLVL 20
Flagging severity level ....FLAG 0
File type ...........FILETYPE *DATA
Member, if desired . . . . . . . MBR *FILE
Text ’description’ . . . . . . . TEXT ’Temporary File’
Bottom
F3=Exit F4=Prompt F5=Refresh F10=Additional parameters F12=Cancel
F13=How to use this display F24=More keys
Figure 115. Create Temporary Resource File panel
116 APU User’s Guide