JVC GY-HM700E Camera Accessories User Manual


 
113
Stream Transmission to a Non-linear
Editing System
Playback images on the camera recorder can be stream
output during editing using a non-linear editing system.
Loading to a Non-linear Editing System
in Play Mode
1 Perform the following settings on the camera
recorder.
A Set the [HD/DV] IEEE1394 terminal mode switch to
ADVB.
B Set the [INT/EXT] IEEE1394 interface terminal switch to
AEXTB.
Memo :
Stream transmission is only possible for DV format images.
2 Connect the IEEE1394 cable.
3 Turn on the power of both the camera recorder and
non-linear editing system.
4 Set the camera recorder to Media mode.
Press the [CAM/MEDIA] selection button to switch to Media
mode. (A Page 7)
Note :
Start recording only after ensuring that the devices are
properly connected.
5 Insert the media to be dubbed.
6 Press the play button (center of the cross-shaped
button) on the camera recorder.
Playback starts.
7 Start loading to the non-linear editing system.
For details, refer to the instruction manual of the non-linear
editing system.
8 Loading is complete.
After loading is complete, press the [CANCEL] button on the
camera recorder to stop playback.
Memo :
Switch the [HD/DV] IEEE1394 terminal mode switch only
after turning OFF the power of the camera recorder.
The operating procedures vary depending on the
characteristics and specifications of the connected devices,
and transfer of data may fail even when the devices are
properly connected.
If noise appears on the screen or audio sound is interrupted,
reconnect the IEEE1394 cable or turn on the power of the
camera recorder again.
Noise may occur in the audio when you turn ON/OFF the
power of the device connected to the [IEEE1394] terminal.
Before performing any of these operations, lower the volume
of the device connected to the camera recorder to the
minimum.
Camera recorder : Recorded SDHC card
IEEE1394
Cable
Signal Flow
[HD/DV] IEEE 1394
Terminal Mode
Switch
[IEEE1394] Terminal
PC
[INT/EXT] IEEE1394
Interface Terminal
Switch