Filter
Top Products
12
Introduction
Side Terminal
A [HD/SD-SDI] HD/SD-SDI Output Terminal (BNC)
(A Page 111)
B
[Y/VIDEO] Y/Composite Video Signal Output Terminal
(BNC) (
A
Page 111)
C
[PB] PB Video Signal Output Terminal (BNC)
(
A
Page 111)
D
[PR] PR Video Signal Output Terminal (BNC)
(
A
Page 111)
E
[REMOTE] Remote Terminal (
A
Page 116)
F
[DC INPUT] DC Input Terminal (
A
Page 21)
Input terminal for DC 12 V power supply. Connects with an
AC adapter.
G
[AUDIO OUTPUT] Audio Output Terminal (RCA)
Output terminal for audio signals.
●
Input audio signals are output during Camera mode.
●
Playback audio signals are output during Media mode.
●
Audio from input audio signals is output during HD/DV signal
(IEEE1394) input.
Memo :
●
Alarm tone is not output.
H
[HD/DV] IEEE1394 Terminal Mode Switch
(
A
Page 112)
I
[INT/EXT] IEEE1394 Interface Terminal Switch
(
A
Page 112)
For selecting a valid IEEE1394 interface terminal.
J
Shoulder Pad Slide Button
For adjusting the shoulder pad position. Press this button to
adjust the shoulder pad K position to the front or back.
K
Shoulder Pad
L
[USB] USB Terminal (
A
Page 115)
M
[IEEE1394] IEEE1394 Terminal (4-pin)
For connecting digital video equipment with IEEE1394
terminal using an IEEE1394 cable (sold separately).
To enable this terminal, set the [INT/EXT] IEEE1394 terminal
switch I to [EXT].
(
A
Page 112 [IEEE1394 Connection])
(
A
Page 114 [Stream Transmission to a Non-linear Editing System])
Note :
●
When connecting IEEE1394 cables, check that the
connectors are facing the right direction before you insert.
Memo :
●
Put on the covers when the connectors are not in use.
Names of Parts (continued)
[EXT]
Enables IEEE1394 signals from the [IEEE1394]
terminal M.
[INT]
Enables the Accessory Connector B at the rear
of the camera recorder. (A Page 13)
A
C
E
F
G
D
B
HI
J
K
L
M