Filter
Top Products
5
Storage and Usage Locations
Ⅵ Allowable ambient temperature and humidity
Be sure to use this device within the allowable temperature range of
0
I
to 40
I
and a relative humidity of 30 % to 80 %. Using this
device at a temperature or humidity outside the allowable ranges
could result not only in malfunction but also serious impact on the
CCD elements as small white spots may be generated.
Ⅵ Strong electromagnetic waves or magnetism
Noise may appear in the picture or audio and/or the colors may be
incorrect if the camera is used near a radio or television transmitting
antenna, in places where strong magnetic fields are generated by
transformers, motors, etc., or near devices emitting radio waves,
such as transceivers or cellular phones.
Ⅵ Use of wireless microphone near the camera
When a wireless microphone or wireless microphone tuner is used
near the camera during recording, the tuner could pick up noise.
Ⅵ Avoid using or placing this device in the following places.
● Places subject to extreme heat or cold
● Places with excessive dirt or dust
● Places with high humidity or moisture
● Places subject to smoke or vapor such as near a
cooking stove
● Places subject to strong vibrations or unstable surfaces
● In a parked car under direct sunlight or near a heater for
long hours
Ⅵ Do not place this device at places that are subject to
radiation or X-rays, or where corrosive gases occur.
Ⅵ Protect this device from being splashed with water.
(Especially when shooting in the rain)
Ⅵ Protect this device from getting wet when shooting on a
beach. In addition, salt and sand may adhere to the camera
body. Be sure to clean the camera after use.
Ⅵ Protect this device against penetration of dust when using
it in a place subject to sandy dust.
Transportation
Do not drop or hit this device against a hard object when
transporting.
Maintenance
Ⅵ Turn off the power before performing any maintenance.
Ⅵ
Wipe the external cabinet of the device with a soft cloth. Do not
wipe the body with benzene or thinner. Doing so may cause the
surface to melt or turn cloudy. When it is extremely dirty, soak the
cloth in a solution of neutral detergent, wipe the body with it, and
then use a clean cloth to remove the detergent.
Power Saving
Ⅵ
When this device is not in use, be sure to set the [POWER]
switch to
A
OFF
B
in order to reduce power consumption.
Batteries
Ⅵ The following batteries can be used on this device.
GY-HM700CHU/GY-HM700U
: Dionic90 (Anton Bauer)
GY-HM700CHE/GY-HM700E
: Endura-7 (IDX)
* Models with an E suffix are for the European market and
will not employ the UL Listing mark.
Ⅵ Make use of the recommended batteries. Heavy batteries
may fall off if not used correctly.
Regular Inspection (Maintenance)
Under normal environment, dust will accumulate on the
camera recorder when it is used over a long period. Dust
may enter the camera especially if it is used outdoors. This
may affect the image and sound quality of the camera
recorder. Check and replace the fan after every 9000 hours
(suggested guideline).
You can check the usage time of the fan at [Others...]
menuB[System Information]B[Fan Hour]. (A Page 88)
If the fan is used for more than 9000 hours without
replacement, AFAN MAINTENANCE REQUIREDB will be
displayed every time you turn on the power.
Others
Ⅵ Do not insert objects other than the memory card into the
card slot.
Ⅵ Do not block the vent on the device.
Blocking of the vent causes internal heating and may lead to
burns and fires.
Ⅵ Do not turn off the [POWER] switch or remove the power
cable during recording or playback.
Ⅵ The camera may not show stable pictures for a few
seconds immediately after the power is turned on, but this is
not a malfunction.
Ⅵ When the video signal output terminals are not in use, put
on the covers to prevent damage to the terminals.
Ⅵ Do not drop this device or subject it to strong impact or
vibration as it is a precision equipment.
Ⅵ Optical performance of lens
Due to the optical performance of the lens, color divergence
phenomena (magnification chromatic aberration) may occur
at the periphery of the image. This is not a camera
malfunction.
SDHC Cards
Use an SDHC card (4 GB to 32 GB) with Class 6 or higher
performance.
* Using cards other than those from Panasonic, TOSHIBA or
SanDisk may result in recording failure or data loss.
Precautions for Proper Use