Filter
Top Products
85
* Default values are indicated in bold characters.
Item Setting Values Function
TC/UB
On
Off
For specifying whether to display the time code/user’s bit rate in the status display on the LCD
monitor and viewfinder screens.
On : Displays the time code or user’s bit rate. Whether time code or user’s bit rate is
displayed is determined by the setting of the [TC DISPLAY] switch on the inner panel of
the camera recorder’s LCD monitor.
Off : Hides the time code or user’s bit rate.
Audio Meter
On
Off
For specifying whether to display the audio level meter in the status display on the LCD monitor
and viewfinder screens.
On : Displays the audio level meter.
Off : Hides the audio level meter.
Battery Info
Time
Capacity%
Voltage
For setting the display of the status screen when a battery is loaded. The status screen is
displayed on the LCD monitor and/or viewfinder.
The battery information appears only on the STATUS 1 Screen in Camera mode. (A Page 92)
Time : Displays the remaining battery power in minutes. AminB
Capacity% : Displays the remaining battery power in percentage. A%B
Voltage : Displays the current battery voltage in units of 0.1 V. AVB
Memo :
● ATimeB display is disabled when an IDX battery is loaded. Even when ATimeB is selected, this
is displayed as AVoltageB.
● When ATimeB or ACapacity%B is selected, the battery mark that appears before the value
changes according to the remaining battery power.
: 12 % and below, : 13 % - 29 %, : 30 % - 59 %, : 60 % - 100 %
● Display changes to A RESB once the battery power falls below 12 %.
● When calibration of the battery is required, , A CALB appears for 2 seconds after every 30
seconds of the voltage display.
● CALIBRATION is a state that requires renewal of the battery power information. The battery is
able to function as usual without calibration. However, calibration is recommended as correct
information of the remaining power and time cannot be obtained otherwise. For more details,
refer to the instruction manual of the Anton Bauer battery.
● The remaining battery power and remaining time are intended as reference values for the
shooting duration.
Date Style
DMY (E model)
MDY (U model)
YMD
For setting the date display sequence in the status display on the LCD monitor and viewfinder
screens.
DMY : Day/Month/Year
MDY : Month/Day/Year
YMD : Year/Month/Day
Time Style
24hour (E model)
12hour (U model)
For setting the time display in the status display on the LCD monitor and viewfinder screens.
24hour : 24-hour display.
12hour : 12-hour display. (AM/PM)
Shutter Disp.
DEG
SEC
For setting the shutter display in the status display on the LCD monitor and viewfinder screens.
DEG : Displays the shutter speed in degrees in the same way as film cameras.
SEC : Displays the shutter speed in seconds.
Memo :
● ADEGB is selectable only when [Frame & Bit Rate] is set to A24p(SP)B, A24p(HQ)B,
A25p(SP)B, or A25p(HQ)B. When [Frame & Bit Rate] is set to other values, the shutter display
setting is fixed at ASECB and cannot be selected. (A Page 71)
● When a remote control is connected, the shutter display setting is fixed at ASECB regardless
of the [Frame & Bit Rate] setting.
RES
2