JVC GR-DVL9200 Camcorder User Manual


 
16 EN
NOTES:
To remove the shutter sound,
“BEEP/TALLY” on pg. 20.
Even if “MULTI-4” or “MULTI-9” is engaged, Snapshot recording will be performed in the FULL mode during
Digital Zoom. However, the flash will not fire.
In Multi-Analyser 4 or Multi-Analyser 9, the flash is disabled (
pg. 22).
If Snapshot recording is not possible, “PHOTO” blinks when SNAPSHOT is pressed.
If Program AE with special effects (
pg. 25) is engaged, certain modes of Program AE with special effects
are disabled during Snapshot recording. In such a case, the icon blinks.
During playback as well, all Snapshot modes are available. The shutter sound is not heard.
To reduce the Red-Eye effect in the subject’s eyes when the flash fires,
pg. 22.
When a headphone set is connected to the PHONE connector, the shutter sound is not heard from the
speaker, however it is recorded onto the tape.
FULL
OFF
P
L
A
Y
5S
RECORDING
Basic Recording (cont.)
Snapshot
Use your camcorder like a regular camera and take a
snapshot, or several of them in succession.
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1
Set the Power Switch to “ ” or “ ” while pressing
down the Lock Button located on the switch. Pull out
the viewfinder fully or open the LCD monitor fully.
2
Choose the appropriate Snapshot mode from the 5
available by repeatedly pressing SNAP MODE until
the desired snapshot mode indicator appears.
SNAPSHOT RECORDING
1
Press SNAPSHOT.
If you press during Record-Standby . . .
.... “PHOTO” appears and a still image will be
recorded for approx. 6 seconds, then the
camcorder re-enters the Record-Standby mode.
If you press during Recording . . .
.... “PHOTO” appears and a still image will be
recorded for approx. 6 seconds, then the normal
recording resumes.
To Use The Flash (
pg. 22) . . .
.... slide FLASH OPEN in the direction of the arrow
printed on the camcorder. The flash is raised. If the
flash is not needed, push down the flash.
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to
serial photography. (Interval between still images: approx.
1 second)
Power
Switch
Display
SNAPSHOT
Button
Lock Button
SNAP MODE Button
Snapshot mode
MULTI SCREEN Button