JVC GR-DVL9200 Camcorder User Manual


 
8 EN
OFF
P
L
A
Y
5S
END
1
R
W
Z
D
G
S
F
D
S
R
E
I
O
I
A
E
L
A
Y
E
C
D
O
S
I
L
A
T
S
T
E
M
N
F
S
E
T
D
U
M
H
/
E
A
R
O
M
U
T
T
M
T
N
D
O
P
I
I
4
E
E
D
M
M
/
E
E
E
T
R
4
IME
1
I
O
D
D
R
N
N
I
A
E
D
S
T
T
I
S
P
E
D
U
C
C
L
/
A
R
A
R
A
T
T
N
T
E
Y
I
E
I
E
M
/
O
N
E
T
N
IME
1.
1
2
2
.
:
0
0
0
0
Date/Time Settings
The date/time is recorded onto the tape at all times, but its
display can be turned on or off during playback
( pg. 32).
1
Set the Power Switch to “ ” or “5S” while pressing
down the Lock Button located on the switch, and
open the LCD monitor fully or pull out the viewfinder
fully. The power lamp lights and the camcorder is
turned on.
2
Press MENU/BRIGHT. The Menu Screen appears.
3
Rotate MENU/BRIGHT to select “ ”. Press it and
“MODE MENU” appears.
4
Rotate MENU/BRIGHT to select “DATE/TIME
4
” and
press it. The “DATE/TIME” Menu appears.
5
Rotate MENU/BRIGHT to select “DATE/TIME”. Press
it and “day” is highlighted.
Rotate MENU/BRIGHT to input the day. Press it.
Repeat to input the month, year, hour and minute.
When the highlight bar is on “
1
RETURN”, press
MENU/BRIGHT three times. The Menu Screen
closes.
Built-in Clock’s Rechargeable Lithium Battery
To store the date/time in memory, the clock’s rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC
Power Adapter/Charger, or while the battery pack attached
to the camcorder continues to supply power, the clock’s
rechargeable lithium battery is always charged. However,
if the camcorder is not used for approx. 3 months, the
clock’s lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
Power Adapter/Charger for over 24 hours to charge the
clock’s rechargeable lithium battery. Then perform the
date/time setting before using the camcorder.
Note that the camcorder can be used without setting the
date/time.
NOTE:
Even if you select “DATE/TIME”, if the parameter is not
highlighted the camcorder’s internal clock continues to
operate. Once you select the first date/time parameter
(day), the clock stops. When you finish setting the minute
and press MENU/BRIGHT, the date and time begin
operation from the date and time you just set.
Display
MENU/BRIGHT Dial
Power Switch
Lock Button
DATE/TIME Menu
MODE MENU
GETTING STARTED
(cont.)
Menu Screen
Power lamp