JVC GR-DVL9200 Camcorder User Manual


 
EN23
RECORDING
+2
FLASH ADJ.
OFF
P
L
A
Y
5S
END
Flash Brightness Adjustment
When a snapshot ( pg. 16) is taken in the dark the
camcorder fires the flash ( pg. 22) and adjusts the
brightness automatically. You can also adjust the flash
brightness manually. When you find that the snapshots
you took look too bright or too dark, adjust it manually.
1
Set the Power Switch to “ ” or “5S” while pressing
down the Lock Button located on the switch, then
pull out the viewfinder fully or open the LCD monitor
fully.
2
Press MENU/BRIGHT. The Menu Screen appears.
3
Rotate MENU/BRIGHT to select “ ”, and press it.
4
To intensify the flash, rotate MENU/BRIGHT towards
+”. To weaken the flash, rotate it towards “”.
Adjustment range: –3 to +3.
5
Press MENU/BRIGHT twice to close the Menu
Screen.
NOTES:
When the battery power is low, the “ ” setting cannot
be changed.
When you change the subject you are shooting or the
shooting location, set it back to ±0 as described in step 4
and take a snapshot to check the flash brightness. After
doing this adjust to your desired brightness.
Power Switch
Display
Lock Button
Menu Screen
MENU/BRIGHT Dial