JVC GR-DVL9200 Camcorder User Manual


 
56 EN
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
38.
The LCD monitor image is
distorted.
39.
Images on the LCD monitor
are jittery.
40.
Blocks of noise appear
during playback, or there is
no playback picture and the
screen becomes blue.
41.
The LCD monitor, the
viewfinder and the lens have
become dirty (ex.
fingerprints).
42.
An unusual mark appears.
43.
An error indication
(E01 — E06) appears.
44.
The charger indicator on the
AC Power Adapter/Charger
does not light.
45.
Picture does not appear on
the LCD monitor.
46.
When the image is printed
from the printer, a black bar
appears at the bottom of the
screen.
47.
When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
48.
During transport, the lens
cover opens.
38.
•During playback of the
unrecorded portion, High-
speed Search and still
playback, LCD monitor
indications appear distorted.
This is not a defect.
39.
•The speaker volume is too
great.
40.
————
41.
————
42.
————
43.
•A malfunction of some kind
has occurred. In this case the
camcorder’s functions become
unusable.
44.
•The temperature of the battery
is extremely high/low.
•Charging is difficult in places
subject to extremely high/low
temperatures.
45.
•The viewfinder is pulled out.
•The LCD monitor's brightness
setting is too dark.
46.
•This is not a malfunction.
47.
•The DV cable was plugged/
unplugged with power turned
on.
48.
————
38.
————
39.
•Turn the speaker volume
down ( pg. 31).
40.
•Clean the video heads with an
optional cleaning cassette
( pg. 63).
41.
•Wipe them gently with soft
cloth. Wiping strongly can
cause damage ( pg. 57).
42.
•Check the section of the
manual that explains LCD
monitor/viewfinder indica-
tions ( pg. 60, 61).
43.
•Remove the power supply
(battery pack, etc.) and wait a
few minutes for the indication
to clear. When it does, you
can resume using the
camcorder. If the indication
remains even though you
repeat the above two or three
times, please consult your
nearest JVC dealer.
44.
•To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C ( pg. 62).
45.
•Push the viewfinder back in.
•Adjust the brightness of the
LCD monitor ( pg. 12).
•If the monitor is tilted upward
180 degrees, open the
monitor fully ( pg. 13).
46.
•By recording with “DIS”
activated ( pg. 19) this can
be avoided.
47.
•Turn the camcorder’s power
off and on again, then operate
it.
48.
•Do not subject the camcorder
to shock or excessive
vibration during transport.
•Turn the camcorder on and
off. The lens cover closes.
TROUBLESHOOTING
(cont.)