Filter
Top Products
E16
C
R
2
0
2
5
C
R
2
0
2
5
KY-F70B
CAMERA
DIG
ITAL
C
-M
O
U
N
T
Inserting the lithium battery
2. Before recording (continued)
The lithium battery is used to back up the time and date data.
Install the lithium battery (CR2025) before using the unit.
Replace the battery once two year.
If the BATTERY EMPTY message appears when turning on the power, replace the battery with
a fresh lithium battery.
<
Install
>
Remove the screws (2 units) using the attached mini screw-
driver, then open the cover.
Completely insert the lithium battery in the direction of the ar-
row with the + side facing up.
Make sure that the battery is securely in position by the hold-
ers as shown in the diagram.
(To remove the battery, follow the procedure in reverse.)
Screws
Battery compartment
Holders
1.
2.
3.
4.
Replace the cover and retighten the screws.
Mini screwdriver (attached)
MEMO
• The time and date will not be displayed correctly when the battery is not installed. When replacing the
lithium battery, reset the time and date.
Setting the time and date ( ੬ page 26)
• A BATTERY EMPTY message will appear immediately after replacing the battery and turning on the
power. This is not a malfunction. If the message continuously appears after turning on the power the
second time, consult your JVC dealer.
• The BATTERY EMPTY message will not appear when turning on the power immediately after turning
off the unit. Wait at least 20 seconds before turning the power back on.