Filter
Top Products
E38
4. Basic operations (continued)
Saving images from the memory to an MO/Zip
®
disk
It is possible to transfer images stored in the camera’s memory to an MO/Zip
®
drive via the SCSI
terminal when in the FREEZE or PLAY mode. Use a formatted DOS/V disk.
Ⅵ Set to either the FREEZE ( ੬ page 36) or PLAY ( ੬
page 37) mode.
1.
Check to make sure that dip switches 1 and 2 are set to
OFF as shown in the diagram on the left.
2.
Press the SEND button. The data will be sent to the MO
(Zip
®
) disk and a WRITE TO MO (ZIP) ACCEPT FILE
NAME: F70_ⅪⅪⅪⅪ.TIF message will appear for ap-
proximately 3 seconds on the monitor connected to the
MONITOR terminal.
At this time an SCSI output mark will appear.
3.
When data is successfully written to the MO (Zip
®
),
WRITE TO MO (ZIP) OK FILE NAME:F70_ⅪⅪⅪⅪ.TIF
will appear for approximately 3 seconds. (each Ⅺ indi-
cates a number)
4.
If data is not successfully written to the MO (Zip
®
), one
of the following error messages will appear for approxi-
mately 3 seconds.
ERROR : SCSI (check the cable)
ERROR : WRITE (write error)
ERROR : FORMAT (format the disk)
ERROR : DISKFULL (disk is full)
ERROR : DIRECTRYFULL (directory error)
ERROR : READ (read error)
ERROR : MO (Other MO error)
ERROR : ZIP (Other ZIP error)
BUFFER IS FULL :
When sending more than 32 images, no. 33 and
after will be displayed.
ALL VIDEO MEMORY IS FULL :
When the SCSI output mark is , the display is
made when pressing the FREEZE button.
ETOWR I T MO
NAMF I LE E: 0_7F000IFT1.
OK
SEE INSTRUCTION MANUAL
POWER
DC IN
REMOTE
MONITOR
LENS
FREEZE
PLAY
SETDOWN
AW/SELSEND
SCSI
UPMENU
MODE
REC
ON 1 2 3 4
SEND
MODE
MENU
ON 1 2 3 4
Output completed
SCSI
terminal
Undefined
Dip switches
Output confirmation
ETOWR I T MO
F:70_NAME
FILE
IF
T0001.
CCAEPT
Number of recordable
shots remaining
SCSI output mark
SCSI output image mark
• Pressing the SEND button during printing will display
F70_????.TIF. For the file name, check the name displayed
after saving to the disk.
MEMO
Display example when an
MO disk is used.