Filter
Top Products
E28
3. Settings and adjustments for recording (continued)
Monitor adjustment
The colour contrast and brightness are adjusted whilst, built-in colour bar signals of the camera
are being displayed on the PC monitor.
1.
According to the system, set the MONITOR mode to
VGA.
2.
Connect the VGA monitor to the MONITOR terminal.
3.
Set dip switches 4 on the rear of the camera to ON.
4.
Turn the camera power to on.
5.
Adjust the VGA monitor.
MEMO
• For adjustment of the monitor, see the instruction manual of
the monitor.
• The default value of the peak level is set to 0.7 V. To change
the setting to 0.58V, select BAR LEVEL in the SYSTEM SET-
TING screen. ( ੬ Page 60)
• It is not possible to switch between the REC/PLAY modes
while the colour bar is displayed.
• Image data cannot be output to an MO/ Zip
®
drive, printer
or PC while the colour bar is displayed.
Dip switches
MONITOR terminal
SEE INSTRUCTION MANUAL
POWER
DC IN
REMOTE
MONITOR
LENS
FREEZE
PLAY
SETDOWN
AW/SELSEND
SCSI
UPMENU
MODE
REC
ON 1 2 3 4
ON 1 2 3 4
ON 1 2 3 4
Set dip switch no. 3 located on the rear
of the camera to OFF.