Filter
Top Products
E19
Connecting a monitor
Connect the PC monitor (VGA) to the MONITOR terminal on the rear of the main unit.
SEE INSTRUCTION MANUAL
POWER
DC IN
REMOTE
MONITOR
LENS
FREEZE
PLAY
SETDOWN
AW/SELSEND
SCSI
UPMENU
MODE
REC
ON 1 2 3 4
MONITOR terminal
MEMO
• The monitor cable must use clump filter for both ends to minimize emission of unwanted electrical
waves. (Commercially available VGA video cable is recommended)
• For the pin assignment, see page 13 Pin configuration of connectors
• Monitor conditions:
fH: 31.47 kHz
fV: 59.94 Hz
Sync signal: H/V separate, TTL negative polarity
• Dip switch setting ( ੬ page 24)
VGA mode (set dip switch No. 3 to OFF)
Do not connect the unit to a VGA monitor directly when in the SXGA mode (dip switch No. 3 ON)
CAUTION
• Before connecting, make sure that the power of all systems are turned off. Connecting with the power
turned on may result in malfunction.