Filter
Top Products
107
B Auto Function
Function For selecting the operation.
Click [Start] to start the selected Auto function. Click [Stop] to stop the
running Auto function.
Auto Pan : The configured Auto Pan operation is performed.
(A Page 112)
Auto Patrol : The configured Auto Patrol operation is executed. Select
[Patrol Mode]. (A Page 60)
Auto Trace : The configured Auto Trace operation is performed.
(A Page 113)
Auto Tracking : Auto Tracking is performed. (A Page 55)
During Auto Tracking, Motion Detection deos not work. (A
Page 64)
Note：
● When the [Mode] item of [Auto Return] is set to AAuto PatrolB and Auto
Patrol starts in this screen, the AAuto PatrolB mode of [Auto Return] will
be changed to the mode that was started at this screen.
[Auto Return] (A Page 54)
● When Auto Pan starts, the camera will repeat the left rotate, right rotate or
return operations. When Auto Patrol starts, the camera will complete a
series of operations and return to the start position, and then repeat the
entire process. When Auto Trace starts, the camera will perform a series
of operations before returning to the start position. It will resume after 30
seconds. If Auto Return function is set, Auto function that was started
manually is stopped when Auto Return starts.
Patrol Mode For selecting the mode of the [Auto Patrol] function.
This feature can only be configured when [Function] is set to AAuto PatrolB.
C Preset Position For selecting the preset position.
When the selected position has been registered, the camera will move to the
selected position. (A Page 111)
Use the upper button to set positions in the tens and use the lower button to
set positions in the ones.
E.g.) To select Position Number 35
Click upper [31-40] and click lower [5]
E.g.) To select Position Number 50
Click upper [41-50] and click lower [10]
M
emo:
●
When the upper [91-99] is selected, the lower [10] cannot be selected.
D Zoom This item sets the zoom operation of the lens when clicking the button.
+ : Zoom is set to TELE and the object becomes bigger.
- : Zoom is set to WIDE and the object becomes smaller.
M
emo:
●
When electronic zoom is set to other than Off, the camera will stop
temporarily when switching from optical zoom to electronic zoom and vice
versa, even though the [+] or [-] button of [Zoom] is pressed continuously. To
continue zooming, press the [+] or [-] button of [Zoom] again.
VN-V686WPU_EN.book Page 107 Friday, February 8, 2008 5:20 PM