Filter
Top Products
65
M
emo:
●
The area display position serves as a reference. Make sure to perform operation check.
●
The screen is divided into blocks of 96 (12 horizontal x 8 vertical). Set the angle of view such that the size
of the object for which motion is to be detected is larger than the size of multiple blocks.
●
When [Stabilizer] is set to
A
On
B
, the image is zoomed to 1.3 times. Thus, the number of blocks displayed
on the motion detection setting screen becomes 48 (8 horizontal x 6 vertical). (
A
Page 40)
Note：
●
Flickers of fluorescent lamps may cause motion detection.
●
Changes in brightness due to the light source may be detected as motion.
●
The motion detection feature is not intended to prevent theft or fire. This feature may not function properly
depending on the conditions of the object and settings.
Our company shall not be liable for any accident or damage that occurs.
●
When other client is getting
JPEG/MPEG4
stream from the VN-V686WPU, video images may not appear
on the [Motion Detection] page due to the maximum distribution limit of VN-V686WPU. Stop other clients
before using the [Motion Detection] page.
A Display Screen The screen is divided into blocks of 12 (horizontal) x 8 (vertical). Use this to
set whether to mask each block.
All blocks are masked in the default setting.
The block turns blue when it is clicked, indicating that it is unmasked. Click
again to return to the masked state.
Press the [OK] button to enable this setting.
Use the [Mask All] button to mask all blocks.
Use the [Clear Mask] button to unmask all blocks.
B Detection For setting the On/Off of [Detection].
Press the [OK] button to enable this setting.
Motion detection does not work during [Auto Tracking] (A Page 55).
C OK/Cancel To apply the new parameters, press the [OK] button.
Press the [Cancel] button to cancel the change.
D Level For setting the sensitivity of motion detection.
Increasing the number raises the detection sensitivity level, and hence it is
more sensitive.
Press the [OK] button to enable this setting.
[Setting values : 0 to 10]
E Mask All Masks all blocks.
Press the [OK] button to enable this setting.
F Clear Mask Unmasks all blocks.
Press the [OK] button to enable this setting.
VN-V686WPU_EN.book Page 65 Friday, February 8, 2008 5:20 PM