Filter
Top Products
113
Auto Trace Setting
This item stores and reproduces manual operation.
Click the [Auto Trace] tab on the [PTZ Controller] screen and configure settings at the [Auto Trace]
setting screen.
Note：
●
As Auto Trace performs simple saving of manual operation, the position may be shifted during playback.
●
A
Digital Flip
B
cannot be used during Auto Trace recording. [Auto Flip] (
A
Page 59)
A
B
C
Click the [Auto Trace] tab to display the [Auto
Trace] screen.
Click [Record Start].
The camera will start recording of Pan/Tilt and
Zoom operations. (for approximately 30 seconds)
M
emo:
●
For details on the manual operation, see
[Operation] (
A
Page 106).
When manual operations are completed, click
[Record Stop].
[State] Display
The current status is displayed.
Standby : The camera is on standby. [Record
Stop] is invalid.
Recording : The camera is recording. Click
[Record Stop] to finish recording.
ACompletedB will be displayed.
Completed : Recording is completed. After
ACompletedB is displayed for 3
seconds, AStandbyB will be
displayed.
Timeout : 30 seconds has passed since
recording started. (Operation for the
30 seconds has been recorded.)
After ATimeoutB is displayed for 3
seconds, AStandbyB will be
displayed.
Memory Full
: The operation has exceeded the
number of recordable operations.
Further recording cannot be made
even if it is within 30 seconds.
(Operations before the limit are
recorded.) After AMemory FullB is
displayed for 3 seconds, AStandbyB
will be displayed.
VN-V686WPU_EN.book Page 113 Friday, February 8, 2008 5:20 PM