Filter
Top Products
May 2002 2-1
2 Connecting and Operating the Scanner
This chapter gives instructions for:
• preparing the host computer
• connecting the HR Film Scanner to the host computer
• starting up the scanner system
• preparing to scan an image
• performing a scan
• shutting down the scanner
Preparing the Host Computer
CAUTION: Do not connect power to the scanner.
1. Install the Ultra-Wide SCSI board into the host computer.
IMPORTANT: Check the README file on the CD before you install the
software.
2. Install the SAM software. See Installing the Service and Assembly Module
(SAM) Software on page A-2.