Filter
Top Products
Using the Long Roll Accessory
D-28 May 2002
Checking the Alignment and Adjusting the Sensor
Offsets
1. Using a flashlight, look from the rear of the aperture to check the alignment of
the marked frame with the aperture plate.
The center of the frame should line up exactly with the right edge (from the
front of the scanner) of the aperture plate.
NOTE: The area beyond the aperture plate is not visible when you are
checking the alignment.
Center of the frame
has not reached the
edge of the aperture
plate
Center of the frame
lines up exactly with
the right edge of the
aperture plate
Center of the frame is
beyond the edge of
the aperture plate
Film is
moving left
to right
Film is
moving
right to left