Filter
Top Products
Using the Long Roll Accessory
D-40 May 2002
6. Change the Detection Function Setting to F HS (high speed):
a. Press and hold MODE until F St appears.
b. Press TEACH once. F Ld appears.
c. Press TEACH again. F HS appears.
d. Move SET/ADJ/RUN to RUN.
Programming the Right Sensor
1. Open the plastic cover on the right display.
2. Make sure the operation mode selector is set to L.
3. Move SET/ADJ/RUN to SET.
4. Change the Detection Function Setting to F HS:
a. Press and hold MODE until F St appears.
b. Press TEACH once. F Ld appears.
c. Press TEACH again. F HS appears.
d. Move SET/ADJ/RUN to RUN.
LDRUNSET
MODEADJTEACH