Filter
Top Products
Connecting and Operating the Scanner
2-8 May 2002
Operating the Scanner
Setting the Magnification and Calibrating the
Scanner
Use your host computer’s scanner software to do this procedure.
NOTE: The terminology used in your scanner software may differ from that used
in this document. Refer to the software manual’s instructions for performing
specific operations such as calibrating the scanner and setting the
magnification.
With the empty film holder (70MM-CAL for HR 500 Plus and 4 x 5 for
HR Universal) in place in the scanner:
1. Set the magnification to the desired level.
2. Calibrate the scanner.
Setting the Scan Parameters
Using the software installed on your host computer, set the scan parameters, such
as the area to be scanned and the file that will contain the scanned image.
Selecting the Negative or Positive Balancing Filter
1. Lift open the lamp-and-filter-access door.
P192_0016HC
lamp-and-filter-
access door
lift door open from
here