Kodak EOSDCS 1 Digital Camera User Manual


 
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8-64 Reference — Kodak Driver Software
“Command failure:
unable to free resource
from global memory.
Restart your computer and
try again.”
A problem has occurred
with Windows.
Restart your computer and try
again.
If this does not resolve the
problem, obtain technical support
from your Windows supplier.
“Connect the adapter (if it
is not already connected),
and allow the adapter to
charge the camera for
three minutes before
clicking the Load Camera
Firmware button again.”
The battery does not
have enough power to
update the camera
firmware.
Allow the camera battery to charge
for three minutes from the AC
battery charger/adapter, and then
click the Load Camera Firmware
button again.
“Data transfer from the
camera to the computer
has been interrupted.
Verify that SCSI cables are
connected properly.”
There has been an
interruption in data
transfer between the
camera and the
computer.
Verify that the SCSI cable is
connected properly between the
camera and the computer. If not,
turn both off, reconnect them, and
try again.
“File Error: can not find
the file WINASPI.DLL.
Install or reinstall the
WINDOWS ASPI
software, and remove
other ASPI software if
possible.”
The driver for ASPI is
installed, but an ASPI
compliant host adapter is
not installed in the
computer.
Obtain an ASPI compliant host
adapter, have a technician install
it, and then try again.
The TWAIN compliant
KODAK Driver for ASPI
is installed, as is an ASPI
compliant host adapter,
but the Windows ASPI
files that accompany the
ASPI compliant host
adapter are not installed.
Install the Windows ASPI files that
accompany the ASPI compliant
SCSI host adapter, then try again.
If for some reason the Windows
ASPI files were not supplied with
your host adapter, contact the
source of the host adapter to
inquire about obtaining them.
Even though you may have
installed ASPI files for other
operating platforms (for example
for DOS), the Windows ASPI files
must be installed to use the
KODAK Driver.
Message Possible Cause Suggested Solution