Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparing the Camera and the Computer 4-11
7. While “SCSI” still appears on the LCD, you change the current SCSI
ID by pressing the SCSI ID button repeatedly. The ID rotates through
the values 0 to 7, “PC,” and “PP.” Stop when you have the SCSI ID
you want, using the separate information below for Macintosh and
TWAIN (PC).
A camera set to a SCSI ID currently in use by another connected SCSI
device may not respond to the computer; instead, the camera will
flash the SCSI indicator on the camera back LCD. If this occurs, shut
down the computer, disconnect the camera, reset the SCSI ID on the
camera as described in this section, and try again.
Macintosh: Do not use the SCSI values 0 (usually your internal hard disk) or 7
(usually your computer), do not select “PC” or “PP,” and do not use a number
currently assigned to any other connected SCSI device such as a CD-ROM
drive which is usually number 3 if it is an internal drive supplied by Apple
Computer, Inc.
TWAIN (PC): Do not use a number currently assigned to any other connected
SCSI device. Do not assign the number used by your SCSI host adapter.
Consult your SCSI host adapter manual to see if other SCSI IDs should not be
used.
“PC” SETTING FOR IBM LAPTOP CUSTOMERS (not for use with the
Macintosh):
Use the “PC” SCSI ID setting only if you will be connecting the
camera to an IBM or compatible laptop computer using a PCMCIA-to-SCSI II
adapter (such as the Adaptec SlimSCSI used with EZ-SCSI 4.0 or the New
Media Bus Toaster), to connect the PCMCIA slot on your laptop (not the
camera) to the SCSI connector on the camera. “PC” sets the SCSI ID of the
camera to 1 and turns on active termination in the camera.
When you finish, take the camera out of “PC” mode, turn off the computer
and camera. If left in “PC” mode, a fully charged battery will be exhausted in
approximately eight hours since the camera can not change to low power
mode when this SCSI setting is active.
“PP” SETTING:
The “PP” setting, although it appears, is not currently sup-
ported and should not be selected for use with the Kodak driver.