Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-12 Preparing the Camera and the Computer
Installing a SCSI Host Adapter
(TWAIN PC Only)
The camera connects to your PC at a SCSI port provided by installing one
of the supported SCSI host adapter cards. If your PC already has a sup-
ported card installed, continue at the next section.
CAUTION: Only trained and qualified technical personnel should perform the
following procedure. You should contact a computer service professional to
configure and install an ASPI host adapter card such as those available from
Adaptec, Inc. running EZ-SCSI 4.0 or later. The installer should read all manufac-
turers’ instructions for both the computer and the host adapter before installing
the adapter in your computer.
1. Turn off the power to the computer, then to all peripherals.
2. If the termination power setting on your SCSI host adapter is disabled,
change its setting to enable it.
3. Install the SCSI Host Adapter card for your PC according to the
manufacturer’s installation instructions. When installation is complete,
a SCSI2 connector should be available on the back of your PC. The
figures in this chapter are intended to illustrate a typical computer
(Macintosh or PC).
SCSI2 Port
BACK OF PC AFTER INSTALLING SCSI HOST ADAPTER