Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Reference — Kodak Driver Software 8-67
“The camera is performing
another operation. Wait
briefly and try again.”
You have tried a
command (for example
Copy To), and the
camera is still performing
another operation.
Wait for a short time (for example
wait until the red Card Busy light
on the camera back stops
blinking), and then try again.
“The camera or camera
back was not found. Try
the following.
Check all cables.
Check for SCSI ID
conflict.
Check for dead battery.
Switch to an archive
folder.”
The SCSI cable is not
connected properly.
Verify that the SCSI cable is
connected properly between the
computer and the camera. If not,
turn both off, reconnect the cable,
and try again.
The camera SCSI ID is set
improperly.
Reset the camera SCSI ID so that it
is different from other devices
connected to the computer. To do
so, turn off the camera, then the
computer. Reset the camera SCSI
ID. Restart.
(With a Macintosh computer the
CD-ROM drive is often SCSI ID
number 3; be certain that you
avoid its number.)
You have connected the
camera to a different
computer (or to the same
computer to which you
recently connected an
additional SCSI device),
resulting in a SCSI ID
conflict.
Reset the camera SCSI ID so that it
is different from other devices
connected to the computer. To do
so, turn off the camera, then the
computer. Set the camera SCSI ID
to a unique value. Restart.
(With a Macintosh computer the
CD-ROM drive is often SCSI ID
number 3; be certain that you
avoid its number.)
(Continued on
next page.)
Message Possible Cause Suggested Solution