16
lUsable batteries
m Install four AA-type penlight batteries (1.5V or lower) of any of these types:
(1) Alkaline-manganese (1.5V)
(2) Lithium (1.5V)
(3) NiCd (rechargeable, 1.2V)
(4) Ni-MH (Nickel Metal Hydride) (rechargeable, 1.2V)
n When replacing batteries, use fresh batteries of the same brand.
n High-power manganese batteries are not recommended for use
with the SB-80DX.
n Always carry extra batteries when traveling.
n Refer to “Notes on batteries” on page 96.
CAUTION!
n Do not use batteries not specified in this instruction manual, as this may
cause them to explode, leak corrosive liquids, or catch on fire.
n Do not mix battery brands or types, or use old with new batteries. Otherwise
the batteries may explode, leak corrosive liquids, or catch on fire.
n Do not recharge non-rechargeable batteries in a battery charger.
Otherwise the batteries may leak corrosive liquids, or generate heat.
1
Installing batteries
1
Open the battery chamber lid as indicated
by the arrows.
2
Install the batteries following the i and
j marks as shown. Then close the
battery chamber lid by sliding it into place
while pressing down.