71
Technical operation/Effective Speedlight placement
1
Set the camera’s exposure mode to Aperture-
Priority Auto (A) or Manual (M).
2
Set the camera’s metering system to Matrix
Metering Y or Center-Weighted Metering W.
3
Set the SB-80DX’s flash mode to TTL or D-TTL
auto flash.
4
Position the built-in wide-flash adapter over the
flash head. Press the c or d button to adjust
the zoom-head position to 14mm or 17mm.
5
Tilt the flash head down to –7°.
nThis position is recommended to illuminate the lower
portion of the subject sufficiently in close-up
photography when the SB-80DX is attached to the
camera and used as the only flash unit.
nThe underbar blinks when the flash head is tilted
down to this position.
7°
6
Confirm that the ready-light is on, then shoot.
nWhen the flash has fired at its maximum output and
underexposure may have occurred, the ready-light
on the SB-80DX blinks for approx. 3 sec. To
compensate, use a wider aperture or move closer to
the subject and reshoot.