Filter
Top Products
10
EN
Basic guide
1 Holding the camera
Keep your fingers and the strap away from the lens and the flash.
2 Place the AF frame on the subject while viewing through the viewfinder
3 Adjust the focus
Press the shutter button gently (halfway).
• The focus is locked when a beep tone is output. The AF confirmation mark and the AF
focusing frame light up in the viewfinder.
• The shutter speed and aperture value that have been set automatically by the camera are
displayed.
• The control panel screen is not displayed when the shutter button is pressed.
4 Release the shutter
Press the shutter button all the way (fully).
• The shutter sounds and the picture is taken.
• The card access lamp blinks and the camera starts
recording the picture.
• Never remove the battery or card while the card access lamp mark is blinking. Doing so could
destroy stored pictures and prevent storage of pictures you have just taken.
Shooting
Horizontal grip Vertical grip
Shutter button
Card access lamp
Halfway down
2007.08.16
AF confirmation mark
Aperture value
Shutter speed
All the way down
s0013_e_00_unified.book Page 10 Monday, March 5, 2007 10:04 AM